TASOLLER Custom Firmware (Host MCU - Application ROM)

See Development for development information.

Yes, the code is a mess. I just wanted to get something onto git y'know :).

Setup

Installing Firmware

Disconnect the PC cable from the TASOLLER
Hold down the FN2 button, while reconnecting the PC cable
HOSTMCU should show as a device
Use Update V1.1.exe from official firmware updates to load the firmware

Currently, Dao CFW is required on the LED board. This is controlled by LED_FIRMWARE_CFW in src/led.h.

Configuring segatools

This firmware emulates arcade IO. As such, segatools' emulation should be disabled, by adding the following lines:

[slider]
enable=0
[io4]
enable=0

Ensure no other [slider] section exists in the file (or if it does, set enable=0 there instead).

The slider MUST be assigned to port COM1. To do this:

Go to Devices and Printers in control panel
Double click TASOLLER
In the Hardware tab, double click USB Serial Device
- If this already reads USB Serial Device (COM1) nothing needs done
Click Change settings
Go to Port Settings -> Advanced...
Under the dropdown for COM Port Number: select COM1

If COM1 is already in use, check what device it is assigned to in Device Manager under Ports (COM & LPT). You may need to enable View -> Show hidden devices.

Pre-chusan Chunithm uses IO3. This firmware does not (and unfortunately cannot) support IO3. It is recommended to enable the HID keyboard mode, and continue to use keyboard input for IRs.

Controls

General

Tap FN1 to insert a coin. FN2 is currently unbound.

Configuration

Hold FN1 for configuration:

Pad 1/2 (cell 0): Left tower colour
Pad 3/4 (cell 1): Ground colour
Pad 5/6 (cell 2): Ground colour when pressed, and separator colour
Pad 7/8 (cell 3): Right tower colour
Pad 9/10 (cell 4): No function
Pad 11/12 (cell 5): Toggle rainbow effect on/off
Pad 13/14 (cell 6): Increase/decrease ground brightness
Pad 15/16 (cell 7): Increase/decrease tower brightness
Pad 17/18 (cell 8): No function
Pad 19/20 (cell 9): System volume up/down
Pad 21/22 (cell 10): Holds Enter for 5 seconds (insert Aime card)
Pad 23/24 (cell 11): No function
Pad 25/26 (cell 12): Increase/decrease sensitivity
Pad 27/28 (cell 13): No function
Pad 29/30 (cell 14): No function
Pad 31/32 (cell 15): Toggle HID keyboard mode

To enter the system test menu, double-tap FN2. This will mirror the on-screen controls, and additionally adds controls for the TEST and SERVICE buttons on a real cabinet. Double-tap FN2 again to leave this mode on the controller (note that this is not synced with the game exiting the menu!).

Cell 6 and 7 are the TEST button, and cell 8 and 9 are the SERVICE button.

To access the TEST and SERVICE buttons without entering the test menu, hold FN2 instead.

Keyboard Mapping

When the HID keyboard is enabled, the following mapping (UMIGURI defaults) is used:

I8U7Y6T5R4E3W2Q1
9KMJNHBGVFCDXSZA

with the airs mapped as 0OLP,..

Please note that this is slightly different to stock firmware!

3.1 KiB Raw Blame History